HO - Dockside 0-4-0 Steam Locomotive
Ready To Run
Plastic Body with Can motor and gear mechanism, Knuckle Couplers and operating headlight.

We have discontinued production of these kits
Most repair parts are available.  When we exhaust these repair parts
we do not plan to restock.  This only applies to the HO steam kits, Cary diesel bodies, O Trolleys and All turntables.

#450  Undecorated	#451  Pennsylvania
#452  Union Pacific	#454  Baltimore & Ohio
#455  Santa Fe	#453  RF & P
#456  KATY	#457  Clinchfield
#458  Canadian National	#459  Long Island
#462  NKP	#463  Erie Lack
#464  Illinois Central	#465  Northern Pacific

 

Repair Drawing with Can Motor Dockside

Repair Drawing of old Dockside

  

#460  Valve Gear Kit 
Brass parts for Bowser, English's and Varney Dockside

#461  Superdetail Kit  
Brass parts for Bowser, English's and Varney Dockside

Pilot Coupler
Use KD c #5 coupler, spring and cover. Place spring in cast on pocket. Put coupler in spring and fasten cover in place with a 2-56 screw.

To use underframe #70221 on a Varney Dockside cut away the sides to accept the DC60 motor. Drill a new hole to mount the motor. Use an 0-80 screw as there is very little material.

Life Like Dockside
Use our drivers #17850 & #17851, two #1720 crankpin screws in front holes and two 80006 in rear holes.
File axle slots in frame with a round file to accept our drivers.

Super detail and valve gear kits will fit Varney and Life-Like engines.